Romani Restoration

Wood Floor Refinishing Glendale CA

​Wood Floor Refinishing in Glendale, CA

Glendale sits next to Pasadena and has much of the same housing: Craftsman bungalows, Spanish Revival houses from the twenties and thirties, and a spread of mid-century homes up toward the Verdugo Mountains. The floors in those houses are usually better than the owners think. Wood floor refinishing in Glendale mostly comes down to finding out what’s there and treating it properly.

What we usually find, by house type

Craftsman bungalow, 1910s to 20s
Oak strip, sometimes fir, often under old wax or carpet
Remove old finish and wax, sand carefully, refinish and match stain to the trim
Spanish Revival, 1920s to 30s
Oak strip or parquet, with transitions to tile
Protect the transitions, patch gaps and damage, refinish
Mid-century
Oak, sometimes glued down or covered
Check thickness before sanding, then refinish
Condo or newer unit
Thin engineered wood
Often a recoat only. Limited sanding left in it

What Glendale does to a floor

Glendale runs hotter and drier than the coast, and an old floor can open up gaps in the dry months and tighten again when it’s damp. That’s wood doing what wood does, and we fill gaps selectively instead of chasing every one. West-facing rooms fade, so it’s worth knowing before you choose a stain, since a dark-stained floor will show sun lines differently than a light one.

When boards need replacing, we use the same species and blend the stain so the patch doesn’t announce itself. Parquet patches take more patience than strip floors. Either way, we finish the repair before we finish the floor.

While we're there

Floors often lead to other work in the same house: refinishing kitchen cabinets, wood doors, or the paneling and trim covered under Craftsman home wood restoration. We’re based in Pasadena, so Glendale is close to the shop. We also serve nearby areas, including South Pasadena and Altadena, and beyond. Our general approach to floors is on the wood floor refinishing page.

Glendale floor questions

Can you refinish a hardwood floor that's been under carpet?

Usually, yes. We repair staple holes, pad glue, and stains as part of the job. We check the wood and its thickness first.

Look at the edge of a board at a floor vent or a threshold. Solid wood is one piece all the way down. Engineered wood has layers, with a thin wood layer on top.

Yes. We match species and blend stain so the repair isn’t obvious.

Yes. Glendale is part of our Los Angeles service area. Call (626) 372-7079 for a free estimate.

Call (626) 372-7079 or describe the floor on the contact page. Estimates are free.

Free Estimates Always

Ready to Bring Your Wood Back to Life?

Tell Marco about your project — doors, floors, cabinets or an entire Craftsman home. Estimates are always free and honest.